Ag Leader ParaDyme SAM Code Upload User Manual - Manual (Page 2)

2202 South Riverside Drive, Ames, IA 50010
Phone: 515-232-5363 Internet: http://www.agleader.com
P/N 4002312
Rev B
5. Description of the Software
When the software is started, the window shown on Figure 1 will appear.
Figure 1 – SAM Firmware Upload Tool startup screen
At this point, the user must select a serial port to be used to connect to the SA Module. The
software will list the available COM ports to choose from as shown in Figure
2 .
Figure 2 – COM port selection
Once a COM port has been selected, the Start Comm with SAM button becomes enabled.
Pressing this button will open the COM port and start the communication with the SA Module.
Figure 3
shows the application screen with the button enabled.