Ag Leader Intellislope CAN Simulator Operation - Manual (Page 4)

iv. Press “OK”
v. NOTE: You may also set up two receivers and set receiver 1 to NMEA and
receiver 2 to NMEA 2000. This would then allow you to see two GPS buttons on
the Display. However this could overload your computer’s serial port, only one
receiver is needed for plow control.
e. Go to: Settings
i. Click “Serial Port” and verify the proper serial and COM port settings for your
computer
f. Go to: View
i. Click “Show Elevation”
ii. A blue to red gradient image should now appear
g. If using the sample field, click the “Rewind” button 6 times or place the tractor icon in
desired location.
Page 4 of 5