Ag Leader Versa DirectCommand NORAC UC5 Quick Reference Guides - Manual

PN ?????? Rev A
PN 2006313 Rev A 1
1
DirectCommand
TM
Norac UC5
Quick Reference Guide
AL: 2006313 - ENG Rev C
shows devices communicating
on NORAC UC5 CAN Bus
Firmware Version and Hardware
Revisions shown underneath
Automatic Setup
steps that configure the NORAC system with the sprayer hydraulic functions must perform
this routine after system is installed
Sensors and Valve Drivers
setup of sensors and valve (explained on next page)
Boom Control Module tab
turn motion detection on/off, choose source as GPS or Aux.
Advanced Settings tab
NORAC non-user menu, password required.
Retune tab
recalibrates hydraulic settings and boom geometry
Norac Devices drop-down menu
Setup UC5
Press to Highlight Configuration
4930rx
Application
Configuration Product
Norac
UC5
Automatic
Setup
Automatic
Setup
Sensors and
Valve Drivers
Boom Control
Module
Advanced
Settings
Retune
Firmware Version Unknown
Hardware Version Unknown
Sprayer Configuration Sprayer Model 1
Controller #300
Norac UC5
Controller #300
Firmware Version Unknown
Hardware Version Unknown
Sprayer Configuration Sprayer Model 1
Sensors and
Valve Drivers
Advanced
Settings
Retune
Boom Control
Module