Operations, Power up the server, Power down the server – HP ProLiant DL360 G5 Server User Manual
Page 18: Access the hp systems insight display
Operations 18
Operations
In this section
Power up the server ................................................................................................................................ 18
Power down the server............................................................................................................................ 18
Access the HP Systems Insight Display ...................................................................................................... 18
Extend the server from the rack ................................................................................................................ 19
Remove the access panel ........................................................................................................................ 20
Install the access panel ........................................................................................................................... 20
Remove the PCI riser board assembly ....................................................................................................... 20
Install the PCI riser board assembly .......................................................................................................... 21
Remove the power supply air baffle.......................................................................................................... 21
Remove the processor air baffle ............................................................................................................... 22
Remove and install a fan module.............................................................................................................. 22
Power up the server
To power up the server, press the Power On/Standby button.
Power down the server
WARNING: To reduce the risk of personal injury, electric shock, or damage to the
equipment, remove the power cord to remove power from the server. The front panel
Power On/Standby button does not completely shut off system power. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
IMPORTANT: If installing a hot-plug device, it is not necessary to power down the server.
1.
Back up the server data.
2.
Shut down the operating system as directed by the operating system documentation.
3.
If the server is installed in a rack, press the UID LED button on the front panel. Blue LEDs illuminate on
the front and rear panels of the server.
4.
Press the Power On/Standby button to place the server in standby mode. When the server activates
standby power mode, the system power LED changes to amber.
5.
If the server is installed in a rack, locate the server by identifying the illuminated rear UID LED button.
6.
Disconnect the power cords.
The system is now without power.
Access the HP Systems Insight Display
To eject the HP Systems Insight Display:
1.
Press and release the display.