HP Z210 Convertible Minitower-Workstation - Manual (Page 61)

10 Installing optical disk drives
This section describes how to install an optical disk drive (ODD) in the workstation.
Installing an optical drive in an HP Z210 CMT
Workstation
This section describes how to install an optical disk drive in the HP Z210 CMT Workstation in the mini-
tower and desktop configurations.
Installing an optical drive (mini-tower configuration)
1. Follow the procedures described in Preparing for component installation on page 34 to prepare
the workstation for component installation.
2. If necessary, remove the EMI filler from the front of the optical bay.
3. Install four black metric M3 guide screws into the drive. Spare metric M3 screws are stored on the
side of the drive bays.
Figure 10-1 Installing the guide screws
ENWW Installing an optical drive in an HP Z210 CMT Workstation 53