HP Z210 Convertible Minitower-Workstation - Manual (Page 55)

4. Push the sled containing the HDD into the selected bay until it snaps into place (1) as shown in the
following figure.
Figure 9-3 Installing the HDD drive
5. Attach a power cable (2), and a data cable (3), to the hard disk drive.
CAUTION: To avoid crushing or pinching the data cable when you replace the access panel,
use the HP-supplied data cable with right-angle connectors.
NOTE: Connect data cables to lower-numbered drive connectors first on the system board. To
identify hard disk drive ports, refer to the workstation service label on the side access panel.
NOTE: Blue SATA ports (numbered zero and one) support SATA Gen 3 (6 Gbit/sec).
6. Replace all components that were removed in preparation for component installation.
Installing an HDD in an HP Z210 SFF Workstation
To install an HDD:
1. Follow the procedures described in Preparing for component installation on page 34 to prepare
the workstation for component installation.
ENWW Installing a hard disk drive 47