HP Z210 Convertible Minitower-Workstation - Manual (Page 43)

Z210 CMT Z210 SFF
Pull up on the handle (1), slide the cover 1.27 cm (0.5
inches) toward the rear of the system (2), then rotate the
cover off the chassis (3). Lift the side access panel handle (1), and remove the side
access panel (2).
4. Raise the expansion card retention clamp and remove the expansion card slot cover as shown in
the following illustrations, if applicable.
Z210 CMT Z210 SFF
Open the card retention clamp by pressing down at the
green touch points (1), and then lift the slot cover from the
chassis (2). Lift the card retention clamp at the green touch point to
open it, then lift the slot cover from the chassis.
ENWW Preparing the workstation for component installation 35