Preparing for component installation, Disassembly and installation preparation, 6 preparing for component installation – HP Z210 Convertible Minitower-Workstation User Manual
Page 42: Preparing the workstation for component
6 Preparing for component
installation
To facilitate the installation of components, several steps can be taken to prepare the workstation. This
section describes how to prepare your workstation for component installation.
Disassembly and installation preparation
Use the following table to determine the order of workstation disassembly required before installing
components. (Your workstation components may be different than those listed.)
Table 6-1
Workstation component installation
To install...
Remove...
Then remove...
Then...
Then...
Memory
Chassis locks
Side access panel
Expansion card (PCI/
PCIe)
Chassis locks
Side access panel
Hard drive
Chassis locks
Side access panel
Rotate front drive cage
to upward position
(Z210 SFF)
Rotate power supply
to upright position
(Z210 SFF)
Optical drive
Chassis locks
Side access panel
Remove front bezel
*
See the workstation Maintenance and Service Guide for chassis lock locations and operation instructions.
Preparing the workstation for component
installation
To prepare the workstation:
NOTE:
The workstation contains green plastic touch points at locations where you must manipulate a
button or lever. Green touch points on some components indicate tool-less removal of those
components.
1.
Disconnect power from the system.
2.
Unlock the side access panel or remove any chassis locks.
3.
Remove the side access panel as shown in the following illustrations.
34
Chapter 6 Preparing for component installation
ENWW