beautypg.com

HP Z210 Convertible Minitower-Workstation User Manual

Page 59

background image

7.

Align the guide screws with the slots on the chassis drive cage, press the hard drive down into the

bay, then slide it back until it stops and locks in place.

Figure 9-10

Installing the hard drive (drive carrier shown)

8.

Rotate the drive cage and the power supply down to their normal positions.

9.

Replace all components that were removed in preparation for component installation.

Installing a secondary HDD or media card reader into a Z210 SFF

You can install an 8.89 cm (3.5 in) hard drive underneath the 13.3 cm (5.25 in) optical drive. A

media card reader can also be installed at this location. If an optical drive is present, you must remove

it to install the hard drive.

To install a hard drive or media card in the drive cage:

1.

Follow the procedures described in

Preparing for component installation on page 34

to prepare

the workstation for component installation.

2.

Remove the front bezel.

3.

Remove the optical disk drive if it is present. (See

Installing an optical drive in an HP Z210 SFF

Workstation on page 56

.)

ENWW

Installing a hard disk drive

51