HP Netserver E Server series - Manual (Page 7)

1
1 Installation Overview
This chapter contains simplified setup information for your HP NetServer E 45 or
E 50. For complete setup instructions, consult the HP NetServer E 45 - E 50
Installation Road Map. If your NetServer includes an HP SureStore tape backup
device, see the Getting Started With Tape Backup Guide, included in the HP
SureStore Backup Software kit for installation and configuration instructions.
Verify Contents
Unpack and verify the contents of the shipping box against the Contents
Checklist included with your NetServer. If anything is missing or damaged,
contact your reseller.
View the README File
1. Press the power-on button. Open the NetServer front door and press the
CD-ROM drive eject button. Place the HP NetServer Navigator CD-ROM
in the drive and press the eject button again to close the drive. Turn the
power off, wait 10 seconds and turn the power on again. If the system fails
to boot, follow the diagnostic instructions on the screen.
2. Go to the Navigator Main Menu. If the language needs to be changed,
select "Set Preferences," and choose the appropriate language.
3. Select "README File." The README file contains the latest
information to help you install your HP NetServer. Read it carefully before
beginning your installation.
You can now boot the Navigator CD-ROM and run Diagnostic Assistant
if you want to verify system operation as shipped.
4. If you are installing additional hardware, such as memory, accessory
boards, or mass storage devices, you will need to remove the cover. Go to
"Remove the Cover."
If you are not installing additional hardware, go to "Configure the HP
NetServer."