HP Netserver E Server series - Manual (Page 12)

Chapter 1 Installation Overview
6
8. The Tested Products List then displays. Click any product for which you
want to find information.
You can identify a board by the shape of its connector:
Figure 1-4. Connector Identification
Install Additional Mass Storage Devices
If you are installing an IDE drive or internal SCSI devices in certain
configurations, you may need additional cables or adapters. For part numbers for
HP cables, adapters, and trays, and configuration information, see Information
Assistant on the Navigator CD-ROM. For new products, you can use Order
Assistant on the HP web site at this URL:
http://www.hp.com/netserver/order/config/od_asst.htm
Configure the HP NetServer
1. Reassemble the HP NetServer and connect the power cord.
2. If you have installed ISA non-plug-and-play adapter boards, you must
now allocate memory resources to each of these boards. Refer to the
"Installing ISA Non-Plug-and-Play Boards" in Chapter 4, "Accessories,"
for instructions.
3. Turn on the HP NetServer and monitor.