HP StoreVirtual 4000 Storage - Manual (Page 44)

Figure 28 Viewing the Disk Setup tab in an HP StoreVirtual 4730
Figure 29 Diagram of the drive bays in an HP StoreVirtual 4730
Replacing a disk
The correct procedure for replacing a disk in a storage system depends upon a number of factors,
including the RAID configuration, the data protection level of volumes and snapshots, and the
number of disks being replaced. Replacing a disk in a storage system that is in a cluster requires
rebuilding data on the replaced disk.
Replacing a disk in a storage system includes the following basic steps.
•
Planning for rebuilding data on either the disk or the entire storage system
•
Physically replacing the disk in the storage system
•
Rebuilding RAID on the disk or on the storage system
NOTE: Because data is distributed evenly across all drives in a RAID set, it is likely that all drives
in a system will wear at the same rate.
Table 11 (page 45) lists disk replacement requirements for specific configurations and storage
systems.
44 Configuring RAID and Managing Disks