HP XP Performance Advisor Software - Manual (Page 75)

where:
–jid The journal ID that is being queried.
–resp
The journal LDEV’s read and write response time.
–st
hh:mm:ss>
Constrain by a certain start time.
–et
hh:mm:ss>
Constrain by a certain end time.
–ms The delimiter for delimited display.
–auth The username and password.
–pf Can be used in place of –auth.
NOTE:
The password file must be created using the encrypt command only.
–d Set the delimiter for delimited display.
–L Show column headers with delimited data.
–hr Display human readable output.
–? Prints this usage statement.
NOTE:
The -st and –et options are supported with –pid option only. The array serial number and –dkc are
required elements.
JNL sample output
The following are output data samples for the CLUI shell script described in the previous section:
jnl -hr -dkc 10001
JID MU CTG JNLS AP U(%) Q-Marker Q-CNT Num LDEV#
0 0 0 3 1 0 109095574 0 3 1287
0 0 0 3 1 0 109095574 0 3 1288
0 0 0 3 1 0 109095574 0 3 1289
0 1 0 3 0 0 0 0 3 1287
0 1 0 3 0 0 0 0 3 1288
0 1 0 3 0 0 0 0 3 1289
0 2 0 3 0 0 0 0 3 1287
0 2 0 3 0 0 0 0 3 1288
0 2 0 3 0 0 0 0 3 1289
0 3 0 3 0 0 0 0 3 1287
0 3 0 3 0 0 0 0 3 1288
0 3 0 3 0 0 0 0 3 1289
HP StorageWorks Performance Advisor XP Software command-line user interface user guide 75