HP XP Performance Advisor Software - Manual (Page 52)

User host configuration script (USERHOSTCONFIG)
This CLUI script enables you to request the host configuration information.
USERHOSTCONFIG usage
Following is the general format of the command to invoke the script:
[-filein in_name | -streamin | -database colon:separated:no_spaces]
-fileout out_name -streamout -header -send -ms management_station_name
[-auth user:password | -pf password_file] -?
where:
–filein When repeated, only uses the last in_name.
–streamin The default input value.
–database
rated:no_spaces>
A list of host names.
TIP:
The word "all" by itself, without the quotation marks, is used to send each host’s
information.
–fileout When repeated, uses the last out_name.
TIP:
This parameter is effective only if all the input records are parsed without error.
–streamout Outputs to the console unless redirected elsewhere.
TIP:
This parameter is effective only if all the input records are parsed without error.
–header Applies only when an output is selected.
TIP:
The software ignores an incoming header line in an input file or stream-in.
–send Sends the configuration records to the management station.
TIP:
This parameter is effective only if all the input records are parsed without error.
–ms
tion_name>
In the form http://servername or https://servername.
TIP:
The https usage is possible when the management station is set up for SSL.
–auth The user name and password are the same as for the Configuration tab.
–pf Can be used in place of –auth.
NOTE:
The password file must be created using the encrypt command only.
–? Displays the usage message; no parsing or sending is performed.
52 Reporting and configuring CLUI shell scripts