Lund usage, Lund sample output – HP XP Performance Advisor Software User Manual
Page 32
Logical unit disk controller snapshot script (LUND)
The report CLUI application provides a command that displays Logical Unit Disk Controller Snapshot
data. Output for this command is ordered by Host ID.
The required element for this command is -dkc. Optionally, you can specify a management station by
using ms
LUND usage
Following is the general format of the command to invoke the script:
lund [-d
[-mr
[ha
ugrp
where:
–d
An optional parameter used to specify delimited output data. There is no
space between d and the delimiter.
–L
An optional parameter used to specify labeled and delimited output data.
–hr
An optional parameter used to request the data in a human-readable format.
The host ID for which LUN information is reported. The word "all" can
be used to indicate all hosts.
The array serial number. The word "all" can be used to indicate all DKCs.
–ms
The address of a management station in the form
.
–auth
A username and password pair in the form username:password.
–dver
Indicates how the data must be displayed. XXXXXX is a version number.
Currently supported values are 010500, 010600, and 015100. The
default value is 010500.
The maximum number of records to return. You cannot specify a number of
records higher than 16000.
Constrains the output to a specific RAID group. The word "all" can be used
to indicate all hosts. Not adding this switch has the same effect.
Constrains the output to a specific CHP Port. The word "all" can be used to
indicate all hosts. Not adding this switch has the same effect.
Constrains the output to a specific ACP Pair. The word "all" can be used to
indicate all hosts. Not adding this switch has the same effect.
–?
Prints the usage statement.
–ugrp
Constrains the output by User Group ID. Can be used interchangeably
with –dkc or –ha.
LUND sample output
The following are output data samples for the CLUI shell script described in the previous section:
32
Reporting and configuring CLUI shell scripts