HP ProLiant ML350e Gen8 v2-Server User Manual
HP Computer hardware
Table of contents
Document Outline
- HP ProLiant ML350e Gen8 v2 Server User Guide
- Abstract
- Notice
- Contents
- Component identification
- Front panel components
- Front panel LEDs and buttons
- Rear panel components
- Rear panel LEDs
- System board components
- Smart Array SAS RAID controller card components
- SAS and SATA device numbers
- SAS and SATA drive LED combinations
- FBWC module LED definitions
- Hot-plug drive LED definitions
- Fan locations
- Redundant power supply connectors
- Operations
- Power up the server
- Power down the server
- Unlock the front bezel
- Lock the front bezel
- Remove the front bezel
- Install the front bezel
- Remove the access panel
- Install the access panel
- Remove the PCI air baffle
- Remove the system air baffle
- Install the system air baffle
- Remove the full-length expansion board
- Remove the fan modules and the fan blank
- Install the fan modules and the fan blank
- Setup
- Hardware options installation
- Introduction
- PCI air baffle option
- Second processor option
- Memory options
- Memory configurations
- General DIMM slot population guidelines
- Installing a DIMM
- Drive options
- Optical drive option
- FBWC options
- Installing an expansion board
- Eight-bay SFF drive cage option
- Four-bay LFF drive cage option
- Redundant hot-plug power supply enablement kit option
- Smart Array cable option
- Power supply module
- HP Trusted Platform Module option
- Cabling
- Software and configuration utilities
- Troubleshooting
- System battery replacement
- Regulatory information
- Electrostatic discharge
- Specifications
- Support and other resources
- Acronyms and abbreviations
- Documentation feedback
- Index