HP ProLiant ML350e Gen8 v2-Server - Manual (Page 39)

Hardware options installation 39
7. Install the access panel (on page 26 ).
8. Return the server to an upright position.
9. Lock the front bezel (on page 24 ).
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server (on page 23 ).
Second processor option
The server supports single-processor and dual-processor operation.
CAUTION: To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor
configurations must contain processors with the same part number.
IMPORTANT: If installing a processor with a faster speed, update the system ROM before
installing the processor.
To install the component:
1. Power down the server (on page 23 ).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Unlock the front bezel (on page 24 ).
4. Place the server on its side.
5. Remove the access panel (on page 25 ).
6. If installed, remove the PCI air baffle (on page 27 ).
7. Remove the system air baffle (on page 28 ).