HP StorageWorks XP Remote Web Console Software - Manual (Page 33)

3 Preparing for XP Snapshot Operations
This chapter describes the requirements for using XP Snapshot, the installation procedure for XP
Snapshot, and calculation of the number of pairs that XP Snapshot can create. Read this chapter
before you start the operation of XP Snapshot.
•
“System Requirements” (page 33)
•
“Operational Requirements” (page 35)
•
“Requirements for Maintaining XP Snapshot” (page 41)
•
“Installing and Uninstalling XP Snapshot” (page 42)
•
“Starting XP Snapshot” (page 42)
System Requirements
XP Snapshot operations involve the storage system containing the primary and secondary volumes
and the licensed XP Snapshot and XP Business Copy feature enabled on Remote Web Console.
The system requirements for XP Snapshot are as follows.
Volume Requirements
XP Snapshot uses P-VOLs, S-VOLs, and pool-VOLs. The requirements (such as emulation type or
path definition) for the volumes used for XP Snapshot are described in this section.
XP Snapshot supports RAID1, RAID5, and RAID6.
Table 14 P-VOL Requirements
Requirement Item
Logical volume (LDEV)
LUSE volume can be specified.
NOTE: A LUSE P-VOL must be paired with an S-VOL of the same size and the
same structure. For example, if a LUSE P-VOL is created by combining volumes of
1 GB, 2 GB and 3 GB in this order, you must specify a LUSE volume which has
exactly the same size and the same combination order as the S-VOL.
You cannot specify the following volumes as XP Snapshot P-VOLs.
• Volumes used as pool-VOLs
•
Volumes used as S-VOLs of XP Snapshot pairs
Volume type
OPEN-V Emulation type
16,384 Maximum number
Required Path definition
4 TB Maximum capacity
System Requirements 33