HP StorageWorks XP Remote Web Console Software User Manual
Page 106

Table 33 Cause of Error and the Result of RAID Manager Command (SSB) (continued)
Cause of Error
RAID Manager Command
SSB2
SSB1
paircreate,
pairsplit,
pairresync,
pairresync -
pairresync -
Since you specified the
volume that is in process of
formatting as the XP
Snapshot P-VOL, the
command ends abnormally.
paircreate,
pairsplit,
pairresync,
pairresync -
pairresync -
9728
Since you specified the
volume whose emulation
type is other than OPEN-V
as the XP Snapshot P-VOL,
the command ends
abnormally.
paircreate,
pairsplit,
pairresync,
pairresync -
pairresync -
9729
Since the volume you
specified as the XP Snapshot
P-VOL has the command
device setting, the pair
cannot be created.
paircreate
972a
Since the capacity of the
volume you specified as the
XP Snapshot P-VOL exceeds
the supported size (4TB), the
pair cannot be created.
paircreate
972c
Since the capacity of the
volume you specified as the
XP Snapshot S-VOL exceeds
the supported size (4TB), the
pair cannot be created.
paircreate
972e
Since you specified a V-VOL
as the XP Snapshot P-VOL,
the pair cannot be created.
paircreate
972f
Since you specified a
pool-VOL as the XP Snapshot
P-VOL, the pair cannot be
created.
paircreate
9730
When XP Snapshot P-VOL
and XP Continuous Access
Software P-VOL share the
volume, the status of the XP
Continuous Access pair is
other than PSUS or PSUE.
Therefore, the XP Snapshot
pair cannot be restored.
pairresync -
restore
9731
pairresync -
restore
9732
106 Troubleshooting