HP OmniBook 800 Notebook PC - Manual (Page 26)

26
End popup
To remove a PC card
Caution
Never remove an I/O card while an application is open that’s set up to use that
card. Exit the application first. If you remove the card, the application (or the
OmniBook) might behave unpredictably or stop responding until you restart
the OmniBook.
Never insert or remove a plug-in card while the PC card drive is actively
reading or writing data. Wait until the PC card drive is done. Otherwise, you
could lose data or the OmniBook could stop responding.
1. For a card in the upper card slot, slide the card-eject lever toward the end of the
case until the card pops out, then pull out the card.
–or–
For a card in the lower card slot, turn over the OmniBook, release the two
latches on the bottom of the slot tray, and pull out the tray.