HP OmniBook 800 Notebook PC - Manual (Page 16)

16
4. After the label prints, cut it to size as marked.
5. Use your fingernail or a paper clip to pull out the plastic tray from the pocket
above the keyboard. Use a small piece of tape to attach the right end of the strip
to the right end of the tray. Then reinsert the tray.
To access a FN key combination from a keyboard without an FN key
If you are using a docking system with an external keyboard, you can set up
CTRL+ALT as a substitute for FN.
• Enable the external FN key: In OmniBook Tools, mark the Enable External FN
Key option on the Input Devices tab.
• Substitute the keystrokes CTRL+ALT for FN.