HP OmniBook 800 Notebook PC - Manual (Page 25)

25
To insert a card in the lower slot
1. Turn over the OmniBook, release the two latches on the bottom of the slot tray,
and pull out the tray.
2. Lift or push the plastic spacer out of the tray. (Save the spacer in case you
remove the card later—it keeps dust and dirt from getting inside the case.)
3. Install the new card into the tray with its face up and its connector holes toward
the metal tabs at the end of the tray.
4. Slide the tray fully into the slot and secure its latches.
About RAM Cards
Start popup
About RAM Cards
If you’re using a RAM card with the OmniBook, keep these suggestions in mind:
• For a new RAM card, install its battery before you insert the card.
• Replace the RAM card battery yearly.
When you want to replace a RAM card battery, plug the card into the OmniBook
and make sure the OmniBook stays turned on while you replace the battery. You
can plug in the ac adapter to keep it from turning off. Otherwise, the data on the
card will be lost.