HP ProLiant SL210t Gen8 Server - Manual (Page 47)

Hardware options installation 47
9. Route the cable through the air baffle, and then connect the cable to the connectors on the adapter
board.
10. Install the 2U adapter board bracket (on page 23 ).
11. Install the PCI riser cage (on page 21 ).
12. Install the node into the chassis (" Installing a node into the chassis " on page 30 ).
13. Connect all peripheral cables to the node.
14. Power up the node (" Power up the nodes " on page 17 ).
Installing the Mini-SAS P430 cable in a 1U node
1. Power down the node (on page 17 ).
2. Disconnect all peripheral cables.
3. Remove the node from the chassis (on page 17 ).
4. Remove the 1U cable guard (on page 18 ).
5. Remove the 1U air baffle (on page 27 ).
6. Remove the PCI riser cage (on page 20 ).
7. Disconnect and remove the Mini-SAS cable (" Remove the Mini-SAS cable " on page 23 ).
8. If not installed, install a P430 Smart Array controller into the PCI riser cage (" Installing an expansion
board " on page 42 ).
9. Connect the Mini-SAS cable x8 connector to the P430 Smart Array controller.