HP ProLiant SL210t Gen8 Server - Manual (Page 22)

Operations 22
b. Tighten the captive screw.
c. Install the screw to secure the riser cage.
d. If a GPU is installed, connect the 2U adapter cable to the GPU power cable.
2. Install the node into the chassis (" Installing a node into the chassis " on page 30 ).
3. Connect all peripheral cables to the node.
4. Power up the node (" Power up the nodes " on page 17 ).
Remove the 2U adapter board bracket
1. Power down the node (on page 17 ).
2. Disconnect all peripheral cables from the node.
3. Remove the node from the chassis (on page 17 ).
4. If a GPU is installed, disconnect the 2U adapter cable from the GPU power cable.