Extend the server from the rack – HP ProLiant DL160 Gen8 Server User Manual
Page 17
Operations 17
IMPORTANT:
The requirement of extending or removing the server from the rack when
performing installation and maintenance procedures depends on the rail system used:
•
If using a ball-bearing rail system, you can perform most installations and maintenance by
simply extending the server from the rack.
•
If using a friction rail system, to perform installations or maintenance that requires access panel
removal, remove the server from the rack.
To remove the server from an HP, Compaq-branded, Telco, or third-party rack:
1.
Power down the server (on page
2.
Disconnect all peripheral cables and power cords from the server rear panel.
3.
Extend the server from the rack (on page
4.
Remove the server from the rack. For more information, see the documentation that ships with the rack
mounting option.
5.
Place the server on a sturdy, level surface.
Extend the server from the rack
IMPORTANT:
The requirement of extending or removing the server from the rack when
performing installation and maintenance procedures depends on the rail system used:
•
If using a ball-bearing rail system, you can perform most installations and maintenance by
simply extending the server from the rack.
•
If using a friction rail system, to perform installations or maintenance that requires access panel
removal, remove the server from the rack.
1.
Power down the server (on page
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Disconnect all peripheral cables.
WARNING:
To reduce the risk of personal injury or equipment damage, be sure that the rack is
adequately stabilized before extending a component from the rack.
WARNING:
To reduce the risk of personal injury, be careful when pressing the server rail-release
latches and sliding the server into the rack. The sliding rails could pinch your fingers.
4.
Pull down the quick release levers on each side of the server.
If the server does not extend from the rack, pull down each quick release lever, and use a T-25
screwdriver to loosen the screws located within the lever housing.