HP XP P9500 Storage - Manual (Page 79)

Cause of error RAID Manager command SSB2
You cannot create the FS or SS pair for the specified P-VOL because the maximum
number of snapshot ID (MU number) was used. paircreate 97B5
You cannot create the FS or SS pair because of one of the following reasons: paircreate 97B6
• The new snapshot group was being created, but the maximum number of
snapshot groups were defined.
•
The maximum number of pairs are defined in the specified snapshot group.
You cannot create the FS or SS pair because the THP pool is being initialized. paircreate 97B7
The command ended abnormally because the status of all pairs using the specified
P-VOL is “PSUE”. paircreate, pairsplit,
pairresync, or pairresync
-restore 97B9
You cannot create the FS or SS pair by using the consistency group to which the
specified snapshot group belongs because of one of the following reasons: paircreate 97BF
• The specified consistency group is being used for BC/SS.
•
You have reached the maximum number of pairs that you can created in a
consistency group.
•
A pair that uses the same P-VOL exists already in the specified snapshot
group.
The command ended abnormally because the specified MU number is outside
the allowable range. All commands 97C2
The command ended abnormally because microprograms that support FS and
other microprograms are mixed. paircreate, pairsplit,
pairresync, or pairresync
-restore 97C3
The command ended abnormally because of one of the following reasons: All commands 97C4
• The specified pool is neither a FS pool nor a SS pool.
•
The specified pool does not exist.
The command ended abnormally because FS is not installed. paircreate, pairsplit,
pairresync, or pairresync
-restore 97C6
You cannot create the FS or SS pair because the capacity of cache management
devices is insufficient. paircreate 97C7
You cannot create the FS or SS pair because the capacity of the volume you
specified as the P-VOL or the S-VOL of the FS pair is more than the supported
size, which is 4 TB. paircreate 97C8
You cannot create the FS or SS pair because you specified the LUSE volume for
the P-VOL. paircreate 97C9
The command ended abnormally because the pool you specified is not an FS
pool. All commands 97CB
You cannot create the FS or SS pair because of one of the following: paircreate 97CE
•
You created an FS pair using the consistency group number that you used
for SS.
• You created an SS pair using the consistency group number that you used
for FS.
You cannot create the pair because the specified consistency group number is
being used by a snapshot group. paircreate 97CF
The FS or SS pair task failed because the specified S-VOL is wrong. paircreate, pairsplit,
pairresync B912
You cannot obtain the consistency group information because FS is not installed. All commands B9A7
Troubleshooting with RAID Manager 79