HP 3PAR Recovery Manager Software - Manual (Page 84)

Show-Connection
Show-Connection shows connection information for current login RMH user name, all RMH
Hyper-V hosts/clusters, and all Hyper-V Storage Systems associated with the RMH user. The actively
selected Hyper-V will also be shown.
Preconditions
User must first login using Login-Rmh.
Syntax
Any optional parameters require square brackets [ ] around them.
Show-Connection -RmhServerName [-HypervName]
[-ShowMissingStorageSystems] [-Verbose]
Table 54 Show-Connection parameters
Description Optional/Required Parameter
Host name of the RMH Server. This is
FQDN or IP address Required -RmhServerName
If specified, the resulting connections
shown will be for this Hyper-V. Optional -HypervName
Synonyms for Hyper-V are supported.
The localhost is not supported.
If specified, Storage Systems used by
Hyper-V(s), but missing credentials, are
shown. Optional -ShowMissingStorageSystems
Display progress messages. Optional -Verbose
Success Paths
•
Scenario 1: Connection information shown.
RMH Session and all Hyper-V/ Storage System connection information currently established
are shown.
Failure Paths
•
Scenario 1: Session owner is invalid.
Every session command received on RMH Server is validated to originate from the same IP
address that initiated the session. If IP does not match, the command fails.
Unmount-vCopy
Unmount-vCopy unmounts currently mounted Virtual Copy volume(s) for the specified Virtual
Copy and Virtual Machine name. The Hyper-V host used in Login-Rmh is used by the mount
command.
Preconditions
The user must first login with Login-Rmh.
Syntax
Any optional parameters require square brackets [ ] around them.
Unmount-vCopy -RmhServerName [-HypervName] -VcNameUuid
-VmNameUuid [-Timestamp] [-Select]
[-HypervHostName] [-HypervUsername] [-HypervPassword] [-Verbose]
84 HP 3PAR Recovery Manager for Microsoft Hyper-V Powershell Commands