HP 3PAR Recovery Manager Software - Manual (Page 83)

Syntax
Any optional parameters require square brackets [ ] around them.
Set-RmhPolicy -RmhServerName -HypervName
-VmNameUuid [-Expiry] [-Retention] [-SavedStateBackups]
[-Verbose]
Table 53 Set-RmhPolicy parameters
Description Optional/Required Parameter
Host name of the RMH Server. This is
FQDN or IP address Required -RmhServerName
Optionally select Hyper-V host/cluster
to use. If not specified, Hyper-V Required -HypervName
host/cluster must be selected using
Select-Hyperv
. This is FQDN or IP
address. Synonyms for Hyper-V are
supported. The localhost is not
supported.
Name/unique id of VM used to set
policy. Required -VmNameUuid
Integer value followed by letter h or d
for Hours and Days respectively. Use 0
to reset. Optional -Expiry
Integer value followed by letter h or d
for Hours and Days respectively. Use 0
to reset Optional -Retention
Disabled or enabled. Use reset to reset. Optional -SavedStateBackups
Display progress messages. Optional -Verbose
Success Paths
•
Scenario 1: RMH Policy is set.
RMH Policy successfully sets for VM.
Failure Paths
•
Scenario 1: Session owner is invalid.
Every session command received on RMH Server is validated to originate from the same IP
address that initiated the session. If IP does not match, the command fails.
•
Scenario 2: VM name/uuid is not specified.
VM name or uuid must be specified to fetch RMH Policy.
•
Scenario 3: Expiry is invalid.
Expiry specified is invalid. Valid: 1-43800 h, 1-1825 d, or 0 to reset.
•
Scenario 4: Retention is invalid.
Retention specified is invalid. Valid: 1-336 h, 1-14 d, or 0 to reset.
•
Scenario 5: Expiry/Retention settings conflict.
Expiry and retention settings conflict for valid cases on Storage System.
•
Scenario 5: Cannot communicate with VM.
Cannot communicate with VM to validate VM.
Set-RmhPolicy 83