HP 3PAR Recovery Manager Software - Manual (Page 81)

Table 51 Restore-vCopyVM parameters
Description Optional/Required Parameter
Host name of the RMH Server. This is
FQDN or IP address. Required -RmhServerName
Optionally select Hyper-V host/cluster
to use. If not specified, Hyper-V Optional -HypervName
host/cluster must be selected using
Select-Hyperv
. This is FQDN or IP
address. Synonyms for Hyper-V are
supported. The localhost is not
supported.
Select VC by name/uuid. Required -VcNameUuid
Select name/uuid to filter VC selection
by VM. Required -VmNameUuid
Specify timestamp of VC to locate in
the format mmddyyhhmmss. Optional -Timestamp
Bypass confirmation prompt. Optional -Force
If specified, VM will be restarted. Optional -RestartVm
Displays progress messages. Optional -Verbose
Result with Description
This command returns the location of restored Virtual Machine and host name.
Success Paths
•
Scenario 1: VM(s) successfully restores.
Specified VM(s) are successfully restored.
Failure Paths
•
Scenario 1: Session owner is invalid.
Every session command received on RMH Server is validated to originate from the same IP
address that initiated the session. If IP does not match, the command fails.
•
Scenario 2: Storage System session credentials are not provided.
Storage System session credentials are not provided for this command.
•
Scenario 3: License missing for RMH.
License is missing for RMH.
•
Scenario 4: Original mount points do not exist.
The original mount points for VM system files and all VHDs must exist.
•
Scenario 5: Fails to mount Virtual Volumes to Hyper-V host.
Unable to mount Virtual Volumes to Hyper-V host for restore.
•
Scenario 6: Fails to unmount Virtual Volumes from Hyper-V host.
After restore is complete, unmount is unable to complete.
•
Scenario 7: Only one Virtual Copy may be restored at a time.
Filtering of Virtual Copies using -VcNameUuid/-VmNameUuid does not result in only one
Virtual Copy to restore.
Restore-vCopyVm 81