HP ProLiant ML370 G6 Server - Manual (Page 74)

Hardware options installation 74
10. Slide the media device part of the way into the bay.
11. Connect the server data and power cables to the rear of the device.
12. Slide the media drive fully into the bay until it is seated securely.
13. Install the fan cage.
14. Install the air baffle.
15. If removed, install the BBWC battery pack or the FBWC capacitor pack (" Installing the BBWC battery
pack or the FBWC capacitor pack " on page 86 ).
16. Install fan 5.
17. Install the access panel.
18. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
19. Power up the server (on page 22 , " Powering up and configuring the server " on page 40 ).
Installing a full-height media device
1. Power down the server (on page 22 ).
2. Do one of the following:
o Open or remove the tower bezel, as needed (" Open or remove the tower bezel " on page 22 ).
o Extend the server from the rack (on page 24 ).
3. Remove the access panel (on page 25 ).
4. Remove fan 5 (on page 26 ).
5. If installed, remove the BBWC battery pack or the FBWC capacitor pack (on page 27 ).
6. Remove the air baffle (on page 28 ).
7. Remove the fan cage (on page 29 ).
8. Remove the media bay blank (on page 30 ).
9. Remove the DVD-ROM drive (on page 31 ).