HP ProLiant ML370 G6 Server - Manual (Page 29)

Operations 29
6. Remove the air baffle.
Remove the fan cage
IMPORTANT: When installing or replacing server components, one or more fans might need to
be removed. To prevent an orderly or immediate server shutdown, HP highly recommends
powering down the server during these procedures. To determine if powering down is required,
see the specific procedure.
To remove the component:
1. Power down the server (on page 22 ).
2. Do one of the following:
o Open or remove the tower bezel, as needed (" Open or remove the tower bezel " on page 22 ).
o Extend the server from the rack (on page 24 ).
3. Remove the access panel (on page 25 ).
4. Remove fan 5 (on page 26 ).
5. If installed, remove the BBWC battery pack or the FBWC capacitor pack (on page 27 ).
6. Remove the air baffle (on page 28 ).