HP ProLiant ML370 G6 Server - Manual (Page 73)

Hardware options installation 73
21. Install the access panel.
22. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
23. Install the hard drives and hard drive blanks.
24. Power up the server (on page 22 , " Powering up and configuring the server " on page 40 ).
Removable media device options
The server supports the installation of up to two half-height devices or one full-height device in the removable
media bays.
Installing a half-height media device
1. Power down the server (on page 22 ).
2. Do one of the following:
o Open or remove the tower bezel, as needed (" Open or remove the tower bezel " on page 22 ).
o Extend the server from the rack (on page 24 ).
3. Remove the access panel (on page 25 ).
4. Remove fan 5 (on page 26 ).
5. If installed, remove the BBWC battery pack or the FBWC capacitor pack (on page 27 ).
6. Remove the air baffle (on page 28 ).
7. Remove the fan cage (on page 29 ).
8. Remove the media bay blank (on page 30 ).
9. Using a T-15 Torx screwdriver, remove the screws from the blank and install them on the device.