HP IO Accelerator for BladeSystem c-Class - Manual (Page 40)

Maintenance 40
fct2: SN:1149D0969-1121
fct3: SN:1149D0969-1111
In this example, 1149D0969 is the adapter serial number.
If you have multiple IO Accelerator devices installed on your system, use the fio-beacon command
to verify where each device is physically located.
o Inspect the adapter serial number labels on the IO Accelerator devices to determine the serial
numbers. However, HP recommends confirming that each serial number is an adapter serial number
by running the fio-status command. The adapter serial number label resides on the back of all HP
ioDrive Duo devices and HP ioDrive2 Duo devices. On ioDrive Duos, the serial number is located on
the PCB component that is attached to the PCIe connector.
2. Set the module parameter for the fio-config command-line utility. For example:
fio-config -p FIO_EXTERNAL_POWER_OVERRIDE
Where the for this parameter is a comma-separated list of adapter serial numbers. For
example:
1149D0969,1159E0972,24589
The -p option makes the parameter persistent after reboot.
fio-config /dev/fct -p PCIe_GLOBAL_SLOT_POWER_LIMIT 74750
Where is the device number for the device relative to the specified adapter serial
number. For example:
fio-config /dev/fct2 –p PCIe_GLOBAL_SLOT_POWER_LIMIT 74760
3. To enforce any parameter changes, you must reboot or unload and then load the drivers.