Ethernet settings (advanced settings) screen – HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem User Manual
Page 90

Virtual Connect networks 90
Ethernet Settings (Advanced Settings) screen
Use this screen to perform the following tasks:
•
Set Server VLAN Tagging Support (on page
•
•
Use the Multiple Networks Link Speed Settings (on page
) to set a custom value for preferred link
connection speed or maximum link connection speed.
•
Enable or disable MAC Cache Failover (on page
•
Modify the refresh interval for MAC Cache Failover (on page
•
Enable or disable IGMP Snooping (on page
•
Modify the idle timeout interval for IGMP Snooping (on page
•
Allow or prevent flooding of unregistered IGMP multicast traffic ("
" on page
•
Enable or disable Network Loop Protection (on page
) for all VC-Enet modules in the domain.
•
Reset Network Loop Protection for all server ports in a loop-detected error state.
•
Enable and configure Throughput Statistics ("
Configuring Throughput Statistics
" on page
) for all
ports of each VC-Enet module, including Flex-10 subports.
- Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem Virtual Connect Flex-10.10D Module for c-Class BladeSystem Virtual Connect FlexFabric 10Gb24-port Module for c-Class BladeSystem 4GB Virtual Connect Fibre Channel Module for c-Class BladeSystem