HP LaserJet Pro 400 MFP M425 - Manual (Page 199)

Solve scan to network folder problems
If scan to network folder problems occur, try these solutions:
● Make sure this feature has been set up. If this feature has not been set up, use the setup wizard in the
HP Device Toolbox (Windows) or HP Utility for Mac OS X software to set it up.
● Make sure the Scan to Network Folder feature is enabled. If it has been disabled, enable the feature
through the HP Device Toolbox (Windows) or HP Utility for Mac OS X software.
● Make sure the product is connected to a network.
The scan failed
● Make sure the network path is in the correct format (//host/share/path) and the folder exists.
● Make sure the network directory is readable and writeable.
● If you are using the default file names for scanned files, make sure there are no conflicting file names.
Remove some of the previously scanned files.
● Use the IP address instead of the host name. Make sure the product and host are connected to the same
network.
● If the network folder is password protected, make sure to enter the correct user name and password.
● If a Disk full message displays, remove some files from the network folder.
● Turn the product off, and then on. Scan again.
ENWW Solve scan to network folder problems 183