HP XP P9500 Storage User Manual
Page 155
In Windows Server 2008, if you have selected an EMC CX series LU as the
HDLM management-target device, perform the following steps to
unregister it. Otherwise, go to step 7.
4
.
From Control Panel, choose MPIO.
The MPIO Properties dialog box opens.
5
.
On the MPIO-ed Devices page, select Device Hardware ID DGC RAID,
and then click the Delete button.
6
.
Click the OK button to close the MPIO Properties dialog box.
7
.
Start the removal program.
In Windows Server 2003:
From Control Panel, choose Add or Remove Programs, and then
Change or Remove Programs. From the list of programs, select
Dynamic Link Manager, and click the Change/Remove button.
In Windows Server 2008 (excluding Windows Server 2008 R2):
From Control Panel, choose Programs and Features. From the list
of programs, select Dynamic Link Manager, and click the Uninstall
button. However, if you are using the Server Core environment, see
"Server Core environment".
In Windows Server 2008 R2 or Windows Server 2012:
From Control Panel, choose Add or Remove Programs. From the
list of programs, select Dynamic Link Manager, and click the
Uninstall button. However, if you are using the Server Core
environment, see "Server Core environment".
Server Core environment:
From the Command Prompt window, execute the removehdlm utility
for removing HDLM.
For details about the removehdlm utility, see
for Removing HDLM on page 7-28
.
8
.
The dlmchkpath utility is automatically executed. If a warning dialog box
appears, follow the procedure below:
¢
Cancel the removal. Reconfigure the system into a single-path
configuration, and then perform the removal again. For details about
the dlmchkpath utility, see
The dlmchkpath Utility for Checking HDLM
¢
If a warning dialog box is not displayed, go to the next step.
9
.
Follow the instructions shown in the messages that appear in the window.
If the KAPL09005-E message appears, stop the HDLM manager according
Stopping the HDLM Manager on page 4-15
. After
stopping the HDLM manager, restart the removal program.
10
.
When removal finishes, a dialog box appears, prompting you to restart
the host.
Click the OK button to restart the host.
Creating an HDLM Environment
3-87
Hitachi Dynamic Link Manager User Guide for Windows
®