HP XP P9500 Storage User Manual
Page 105
The dlmprsvkey Utility for Registering an HDLM Persistent
.
If you used a license key file, it will be deleted after the installation
finishes. The KAPL09115-W message will appear if deletion of this file
fails. If this happens, delete the file manually.
17
.
Shut down the host.
Leave the host in a single-path configuration until you check (in step 24)
whether HDLM has been successfully installed.
18
.
For all the hosts that make up the cluster system, perform steps 3 to 16.
19
.
Make sure that all the hosts that make up the cluster system have been
completely shut down.
20
.
Restart each host.
21
.
Log on to Windows again as a member of the Administrators group.
22
.
Execute the dlnkmgr command's view operation to display the status of
each program:
An example of executing the dlnkmgr command's view operation is as
follows:
PROMPT>dlnkmgr view -sys
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster : off
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Remove LU : off
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 128
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
23
.
Use the results of the view operation to check the version of the installed
HDLM.
If x.x.x-xx is displayed in HDLM Version, the correct version of HDLM
has been installed.
24
.
Use the results of the view operation to check that the programs are
running properly.
Creating an HDLM Environment
3-37
Hitachi Dynamic Link Manager User Guide for Windows
®