beautypg.com

Createsite, Description, Syntax – HP StoreVirtual 4000 Storage User Manual

Page 34: Parameters

background image

Description

Name

The CHAP name for the volume. If this is not specified, the IQN of the local
server is used (this parameter is required if run on a storage system).

[chapName]

The CHAP initiator secret for the volume.

[initiatorSecret]

Enter the IP address of the client server that has Application Aware Snapshot
Manager (AASM) installed on it. It will coordinate the snapshot with the

[controllingserver]

applications using SAN volumes. This is required for managed snapshots of
Fibre Channel connected volumes. This is also required for VMware managed
snapshots, enter the Virtual Center Server IP address.

Allow Fibre Channel ports to be assigned to the client. Values are 0—Disable
and 1—Enable. If volumes are attached to a client server via Fibre Channel

[allowfcaccess]

and a value of 0 is entered, the client will lose its ability to communicate with
the attached volumes.

A semicolon delimited list of the unique World Wide Port Name for one or
more Fibre Channel ports. Expected WWPN formatting is 16 Hex characters

[wwpn]

with or without the : character as a delimiter (for example,
20:21:00:0E:B3:01:AB:C6

or 2021000EB301ABC6). Lower case hex

characters a–f are also accepted.

The LUN (1–255) of the boot volume. Valid only for a Fibre Channel attached
volume. If present, then bootvolumename must also be specified.

NOTE:

LUN 255 is not supported by Microsoft Windows.

[bootvolumelun]

The volume name of the boot volume. Valid only for a Fibre Channel attached
volume. If present, then bootvolumelun must also be specified.

[bootvolumename]

Example 45 Windows

cliq createServer serverName=TheServer useCHAP=0

initiator=iqn.1991-05.com.microsoft:w-gregorio.corp.mynetworks.com

login=10.0.1.2 userName=admin passWord=secret

Example 46 SSH

createServer serverName=TheServer useCHAP=0

initiator=iqn.1991-05.com.microsoft:w-gregorio.corp.myworks.com

createSite

Description

Create a site in a multi-site SAN.

Syntax

createSite

{login=} { userName= passWord= | groupName= } {siteName=}

[description=] [primary=] [node=]

Parameters

Description

Name

The IP addresses or DNS-resolvable names of one or more storage systems.

{login}

The authentication user name for the storage system. If you use this parameter,
you must include the passWord parameter with it. Or, you can use the
groupName

parameter instead of userName and passWord.

{userName}

34

Commands

This manual is related to the following products: