Changing pool information, Figure 11 change pool information pane, 11 change pool information pane – HP StorageWorks XP Remote Web Console Software User Manual
Page 38: Figure 11
38
Snapshot XP
NOTE:
Do not enter a pool ID that is already used by another pool. If you enter a pool ID that is
already used by another pool and click Set, an error message appears. In that case, enter a
different number for the new pool ID.
•
Threshold
Threshold of the pool usage rate between 20 and 95.
NOTE:
The threshold unit is percent (%). If the pool usage rate exceeds the threshold, the pool
status changes to Warning. You cannot create new Snapshot XP pairs to a pool in Warning status.
Be careful not to set too small a value for the threshold.
•
Attribute
Software product that uses the pool.
•
Set button
Creates a new pool according to settings in the New Pool pane, and closes the pane.
•
Cancel button
Cancels settings in the New Pool pane, and closes the pane. No pool is created.
Changing pool information
After you create a pool, the only setting you can change is the threshold.
1.
Change the Command View XP or Remote XP Remote Web Console mode to Modify. For more
information about changing the mode, see the HP StorageWorks Command View XP User Guide for XP
Disk Arrays or the HP StorageWorks XP Remote Web Console User Guide for XP12000/XP10000.
2.
Select and right-click the pool you want to change. A pop-up menu appears.
NOTE:
If the pool usage rate is 95% or higher, the pop-up menu does not appear.
3.
Select Change Pool Information. The Change Pool Information pane (
) appears.
4.
Select the threshold value from the Threshold drop-down list.
NOTE:
In the drop-down list, only values higher than the pool usage rate appear.
5.
Click Set. The Change Pool Information pane closes.
6.
Click Apply. A confirmation message appears asking if it is OK to apply the setting to the disk array.
7.
Click OK. The confirmation message closes, and the setting change is applied to the disk array.
Figure 11
Change Pool Information pane
The items in the Change Pool Information pane are same as those in the New Pool pane. However, in the
Change Pool Information pane, you cannot enter or select items other than the Threshold drop-down list.
For more information about items in the Change Pool Information pane, see ”