HP StorageWorks EVA Controller HSG V8.8 Software - Manual (Page 102)

Troubleshooting
102 Command Console V2.5 User Guide
Cluster Integration for the HS-Series Agents
This section describes how to integrate a Windows NT cluster with SWCC.
How to Integrate SWCC with Windows NT
When you integrate a Windows NT cluster with SWCC, you can configure and
monitor a subsystem within the cluster environment. You need the following to
perform cluster integration:
■ A valid, working stable cluster
■ An Agent installed on a disk that is on a non-shared SCSI bus
■ An Agent on each cluster node of the cluster
To integrate a Windows NT cluster with SWCC:
1. Click Settings under the Start menu, and then click Control Panel.
Double-click Services.
The Services window opens.
2. Choose Steam from the drop-down list for the Service field, and then click
the Stop button. Steam, which stands for StorageWorks Enterprise Array
Manager, is the name for the HS-Series Agent service. This action stops
Steam, and its status no longer displays as Started in the Services window.
3. Click Startup. A smaller Services window opens.
4. Choose Manual, and then click OK to disable the automatic start of the
service.
You are returned to the main Services window.
5. Click Close to exit the Services window.
6. Repeat steps 1-5 for each cluster node.
7. Click the Cluster Administrator Utility entry under the Administrative
Tools group.
The program’s main screen opens.
Note: Microsoft develops Cluster Administrator Utility. For further information about
the software, see the appropriate documentation.