HP Storage Mirroring Software - Manual (Page 98)

Job monitoring Page 97 of 135
Viewing the statistics file
The statistics log file created is a binary file. To view the log file, you must run the DTStat
utility from a command prompt. From the directory where Storage Mirroring Data
Migration is installed, run the DTStat command.
Command
DTSTAT
Description
Starts the DTStats statistics logging utility from a command prompt
Syntax
DTSTAT [-p][-i < interval >][-t < filename >] [-f < filename >] [-s < filename >] [-
st < filename >][-IP < address >] [-START < mm / dd / yyyy hh : mm >][-STOP
< mm / dd / yyyy hh : mm >] [-SERVER < ip_address > < port_number >]
Options
l
-p—Do not print the output to the screen
l
-i interval —Refresh from shared memory every interval seconds
l
-t filename —Save the data from memory to the specified binary file
filename
l
-f filename —Reads from a previously saved binary file, filename, that
was generated using the -t option instead of reading from memory
l
-s filename —Saves only the connection data from the data in memory
to an ASCII, comma-delimited file, filename
l
-st filename —Saves only the target data from the data in memory to an
ASCII, comma-delimited file, filename
l
-f filename1 -s filename2 —Saves only the connection data from a
previously saved binary file, filename1, to an ASCII, comma-delimited
file, filename2
l
-f filename1 -st filename2 —Saves only the target data from a
previously saved binary file, filename1, to an ASCII, comma-delimited
file, filename2
l
- IP address —Filters out the specified address in the IP address field
and prints only those entries. Specify more than one IP address by
separating them by a comma.