HP StoreEver Ultrium Tape Drives - Manual (Page 25)

1. M3 mounting screws
2. M3 offset mounting screws
Figure 5 Attaching locating screws in a typical HP ProLiant 350 or 370
Other servers
Attach the appropriate mounting hardware. Refer to the manufacturer’s documentation for instructions.
• If you are installing on a server that requires a tray, place the tape drive in the tray.
• Some servers have snap-on mounting rails attached to the filler panel. These can be removed
and attached to the tape drive with screws.
Install drive
Slide the tape drive into the open bay, aligning the tray or rails with the slots in the bay, as shown
in Figure 6 .
Ultrium Half-Height SCSI Tape Drives 25