HP ProLiant DL145 G3 Server - Manual (Page 48)

Using LO100 48
3. Select the User Privilege level from the list. For more information on user privileges and access rights,
see "User administration (on page 46 )."
4. (Optional) Change the user name.
5. To save the changes, click Set.
Changing user settings through the CLP
The first user is a fixed null value. Customizable users start at user2 and continue through user16. You can
only enable users for log in through the browser. However, you can change the values through any
connection.
1. Log in to the CLP as described in the "Logging in to LO100 (on page 26 )" section.
2. At the command prompt, enter cd map1/accounts.
3. Select a user by entering cd user1 or cd user#, where # is the user you want to modify and a
whole number between 2 and 16.
4. To change the user name, enter set username=. For example:
/./map1/accounts/user2/> set username=testuser2
5. To change the user password, enter set password= and enter the new
password when prompted. For example:
/./map1/accounts/user2/> set password=testpswd2
Passwords are case-sensitive and can contain up to 16 characters.
6. To change the group name enter, set group=. Valid group settings are
administrator, user, oemhp, and operator. For example:
/./map1/accounts/user2/> set group=user
Network settings
You can view and modify network settings for LO100 using a web browser, CLP, or the BIOS Setup
Utility. If you change the IP address, the connection to the server terminates. You must reconnect to the
server using the new IP address.