HP ProLiant DL145 G3 Server - Manual (Page 46)

Using LO100 46
o On ProLiant ML115 G1 servers, press the down arrow (↓) key to scroll down to the Console
Redirection option, and press the Enter key. Verify the following settings:
— Console Redirection—Enabled
— EMS Support (SPCR)—Enabled
— Serial Port Mode—09600 8,n,1
— Flow Control—None
— Redirection After BIOS POST—Always
— Terminal Type—VT100
— Sredir Memory Display Delay—No Delay
4. Press the Esc key to return to the previous screen, or press the F10 key to save the changes and exit
setup.
After enabling Windows® EMS management, you can view the Windows® EMS management console
remotely from a client PC through an established telnet session to the IP address of the target server by
pressing the Esc+Q keys. You can end an EMS session by pressing the Esc+( keys. See your operating
system documentation for instructions on establishing telnet sessions.
NOTE: If you encounter problems logging in to the remote console, be aware that some telnet
programs might require you to enable their send line feed at end of line option. If
the remote console does not respond to the Enter key, try setting this option in your telnet
program.
Hardware Inventory page
The Hardware Inventory page enables you to remotely identify the presence of processors on a target
server. To access this page from a web browser on the main menu navigation bar, click Hardware
Inventory.
User administration
The User Administration option on the main menu navigation bar enables you (if authorized) to edit the
user name and password for existing users. You cannot create a new user. The user password is stored in