HP ProLiant DL145 G3 Server - Manual (Page 24)

Using LO100 24
//192.168.2.1/pub/firmwareimage.bin transferred to
/map1/firmware/firmwareimage
• The reset command cycles the target from enabled to disabled and then back to enabled.
• The set command assigns a specific value to a property or group of properties. The standard
syntax for the set command is set property = new value.
The set command is used to change any property (if applicable.) If the current directory does not
contain the property you want to change, you must specify the target of the property before entering
the property you want to change.
• The start command causes a target to change state to a higher run level.
• The stop command causes a target to change state to a lower run level.
You can between a CLP and a console redirection session by entering start or stop in the
directory, for example, the /./system1/console1/-> directory.
When using the stop command to switch to the CLP session, you must press the ESC key before
using the stop command to return to the CLP session.
• The version command queries the version of the CLP implementation or other CLP elements. For
example:
/./map1/-> version
Version 1.00
/./map1/-> cd firmware
/./map1/firmware/-> version
Version 1.00
/./map1/firmware/-> show
/./map1/firmware
Targets
Properties
fwversion=2.20
Verbs
cd
version
exit
show
reset
load
help
/./map1/firmware/-> show fwversion
fwversion=2.20
/./map1/firmware/-> fwversion
Invalid command
/./map1/firmware/->