Canon Wireless File Transmitter WFT-E7A - Manual (Page 32)

32
These instructions are continued from Chapter 1.
1 Turn the <5> dial to select [Address setting],
and then press <0>.
2 If you set the DNS server setting to [Disable], the
screen on the left is displayed.
Press <0> to select the input position, and then
turn the <5> dial to enter the IP address of the
FTP server.
If you set the DNS server IP address setting to
[Auto assign] or [Manual setting], the screen on
the left is displayed.
For instructions on screen operations, see “Virtual
Keyboard Operation” (p.29).
Enter the FTP server’s server name or IP address.
3 In [Port number setting], enter 00021, in most
cases.
Turn the <5> dial to select [OK], and then press
<0> to go to the next screen.
4 Complete the [Passive mode] settings.
If an Error 41 (“Cannot connect to FTP server”) is
displayed in step 8, setting [Passive mode] to
[Enable] may resolve it.
5 Complete the [Proxy server] settings.
Turn the <5> dial to select [OK], and then press
<0> to go to the next screen.
Configuring FTP Communication Settings
COP
Y