Canon Wireless File Transmitter WFT-E7A - Manual (Page 102)

102
Handling Error Messages
Is another device on the transmitter network using the same IP address as the
transmitter?
X This error occurs if the transmitter is connected to a network where another device
subsequently connects with the same IP address. Change the transmitter’s IP address to
avoid using the same address as another device on the network. Otherwise, change the
IP address of the device that has a redundant address.
What to check on the transmitter
On the transmitter, the network setting is [Auto setting]. Does the error occur under
this setting?
X If you are not using a DHCP server, set the transmitter’s network setting to [Manual
setting] (p.27).
What to check on the DHCP server
Is the DHCP server on?
X Turn the DHCP server on.
Are the DHCP server settings for IP addresses and the corresponding names
correct?
X On the DHCP server, make sure IP addresses and the corresponding names are entered
correctly.
Is the DHCP server functioning correctly?
X Check the DHCP server settings to make sure it is functioning correctly as a DHCP
server.
X If applicable, ask your network administrator to ensure that the DHCP server can be used.
What to check on the network as a whole
Does your network include a router or similar device that serves as a gateway?
X If applicable, ask your network administrator for the network gateway address and enter it
on the transmitter (p.27).
X Make sure the gateway address setting is correctly entered on all network devices,
including the transmitter.
25: Another terminal has set the same IP address
26: No response from DHCP server
COP
Y