Canon XA10 - Manual (Page 168)

Troubleshooting
168
Scene recorded using another device. Cannot play back the scene.
- Scenes that were not recorded with this camcorder cannot be played back.
Select the desired scene number
- A number of scenes have the same recording date but different file control information. This
can occur for example when you edit photos and write the files back to the camcorder. Select a
number to display the corresponding group of scenes.
Some scenes could not be converted
- Some scenes selected for conversion to SD were recorded using another device. These scenes
were not converted.
Some scenes could not be deleted
- Movies that were protected/edited with other devices cannot be deleted with this camcorder.
Some scenes were recorded using another device and cannot be copied.
- Scenes that were not recorded with this camcorder cannot be copied to memory card Y.
Task in progress. Do not disconnect the power source.
- The camcorder is updating the memory. Wait until the operation ends and do not disconnect
the compact power adapter or remove the battery pack.
There are no scenes with the selected rating
- No scenes have been rated yet. Rate the scenes as you like ( 0 116).
- The criteria you used to select scenes by rating resulted in no applicable scenes. Change the
criteria used to select scenes by rating.
This memory card contains scenes. Delete all scenes to use relay recording.
- Save your movies ( 0 134) if necessary, and delete all the movies from the memory card
( 0 97).
This photo cannot be displayed
- You may not be able to display photos taken with other devices or image files created or edited
on a computer.
This scene was recorded using another device and cannot be copied.
- Scenes that were not recorded with this camcorder cannot be copied to memory card Y.
To record video on this memory card, it is recommended to use only the XP+/SP/LP recording
modes
- Movies may not be recorded correctly on this memory card if the recording mode is set to MXP
or FXP mode ( 0 48).
To use the wireless function, insert the Eye-Fi card into slot B.
- You may have inserted the Eye-Fi card into memory card slot X. Insert it into memory card slot
Y.
Too many photos. Disconnect the USB cable.
- Disconnect the USB cable. Try using a memory card reader or decrease the number of photos
on the memory card to fewer than 2,500 photos (Windows), or 1,000 photos (Mac OS).
- If a dialog box appeared on the computer screen, close it. Disconnect the USB cable, and
restore the connection after a short while.
Total play time is too long
- When converting scenes from a story, the maximum total playback time of the scenes to be
converted is 2 hours and 30 minutes. Reduce the number of scenes to be converted to SD.
Unable to recognize the data
- You transferred data to the camcorder recorded using a video configuration that is not
supported (NTSC). Play back the recordings with the device originally used to record them.
COP
Y