Brother PE-DESIGN Ver.432 - Manual (Page 2)

IMPORTANT INFORMATION: REGULATIONS
Federal Communications Commission Compliance Notice
(for U.S.A only)
This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harm-
ful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
– Consult the dealer or an experienced radio/TV technician for help.
Important – About the Interface Cable
This equipment has been certified to comply with FCC standards, which are applied to the U.S.A.
only. A shielded interface cable should be used according to FCC 15. 27(C).
Caution
Changes or modifications not expressly approved by the manufacturer or local sales distributor could
void the user’s authority to operate the equipment.
Canadian Department of Communications Compliance Statement
(for Canada only)
This digital apparatus does not exceed the Class B limits for radio noise emission from digital appara-
tus as set out in the interference-causing equipment standard entitled “Digital Apparatus”, ICES-003
of the Department of Communications
Radio Interference
(220–240V area only)
This machine complies with EN55022 (CISPR Publication 22)/Class B.