Brother NX 600 - Manual (Page 95)

Zipper/piping Insertion 89
3
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
g
Securely tighten the positioning screw with a
screwdriver.
a Positioning screw
h
Topstitch around the zipper.
a Stitching
b Right side of fabric
c Basting stitching
d End of zipper opening
CAUTION
i
Remove the basting stitching.
Inserting a piping
a
Place the piping between two fabrics inside
out, as shown below.
a Fabric
b Piping
c Fabric
b
Refer to the steps of attaching the adjustable
zipper/piping foot on the previous page.
c
Sew along the piping.
d
After sewing, turn them over.
● When sewing, be sure that the needle
does not touch the zipper, otherwise the
needle may bend or break.
1
3
2
4
1
2
3
F3dash-BrotherE_sgml.book Page 89 Friday, September 5, 2003 5:46 PM